PFAFF Piping Foot with Corded Guide

With the Piping Foot with Cording Guide, you can create piping, corded tucks and decorative trims with flawless results.

Compatible with the PFAFF coverlock 4.0, 3.0, and admire air 7000 Coverlock Machine models.

To easily create your own piping:

1. Set the machine for Chainstitch.

2. Use the default stitch settings. Adjust if needed. Note: Although the machine recommends needle D, you will use needle E for this technique instead.

3. Snap on the Piping foot. (The cording guide is not used for this technique.)

4. Place the cord in the groove on the bottom of the foot and pull the cord tail behind the foot about 5cm (2). Note: 1.5 – 2.0mm (1/4 – 5/8) cord can be used.

5. Cut a strip of fabric on the bias, 25mm (1) wide.

6. Wrap the fabric around the cord in the front of the foot. Slide the fabric under the foot.

7. Lower the presser foot and sew over the cord and fabric. (Hold the cord behind the foot as you begin to sew.)

For Corded Tucks: Achieve a trapunto effect when a coverstitch is sewn over a cord in the guide.

1. Set the machine for coverstitch, wide. Note: Although the machine recommends needles C and E, you will use needles D and E for this technique instead.

2. Snap on the Piping foot and attach the cording guide.

3. Insert the cord into the round hole of the cording guide and position it in the groove on the bottom of the Piping foot.

4. Lay the fabric right side up on top of the cord. Slide it under the foot until it is underneath the needles.

5. Lower the needles into the fabric. Lower the presser foot and start to sew at a medium speed. (Hold the cord behind the foot as you begin to sew.)

For Decorative Trim – Use decorative thread and ribbons to create special effects and unique trims.

1. Set the machine for 3-thread ornamental flatlock stitch, wide with decorative thread in the loopers.

2. Snap on the standard presser foot and attach the cording guide.

3. Insert a ribbon 6mm () wide right side down into the rectangular opening in the guide.

4. Place the ribbon under the presser foot to the right side of the needle, leaving a 5cm (2) tail behind the foot.

5. The needle should go down into the machine just beyond, not into, the edge of the ribbon.

6. Sew over the ribbon to make a decorative trim.

Tip:

Make your decorated ribbon long enough to cut it in three pieces, then braid.